|
The Stage I fuel system upgrade is designed for people running a stock setup to 120 horsepower over stock. We take the small restrictive fuel lines and replace them with larger stainless steel braided lines.
The fuel line used is the standard for the automotive industry. It is made up of two different layers. The inner layer is extruded Teflon® and the outer layer is stainless steel braid. This is the ONLY line that is designed to handle diesel fuels, additives, Bio-diesel, Waste Vegetable Oils (WVO) and all additives known to us. (Teflon® is a registered trademark of DuPont Performance Elastomers.)
This fuel line is designed to outlast your engine and truck. The operating temperature of this line is -65 to +450 degrees Fahrenheit. That means your fuel system will still be working even when you stop no matter where you are.
All hose ends are precision machined. These ends are designed to flow the maximum amount of fuel without sacrificing quality and risking cracking or breakage.
All fittings in this kit feature either o-ring seals or washers. No Teflon tape is needed during installation. All fittings are adjustable allowing the fuel line to naturally run without binding or putting pressure on the fitting, which could cause failure.
Don’t be fooled by imitations. Many other companies use smaller lines and drill out the banjo bolt to increase flow. This helps, but it certainly isn’t a good alternative. We use the largest lines and fittings possible without having to use a reducer. In addition, our lines are specially designed for diesel fuels and additives.
This kit doesn’t sacrifice quality or reliability. We don’t believe in that! This kit comes with a 50 year warranty against defects, leaks or anything else that comes up. The only exception is if the lines get cut, pinched and/or damaged by user error.
Please note:
The Stage I Fuel Kit is not compatible with trucks equipped with a dual alternator setup.
The fuel line that we use is the standard for the automotive industry. It is made up of two different layers. The inner layer is extruded Teflon® and the outer layer is stainless steel braid. This is the ONLY line that is designed to handle diesel fuels, additives, Bio-diesel, Waste Vegetable Oils (WVO) and all additives known to us. (Teflon® is a registered trademark of DuPont Performance Elastomers.)
Installation instructions
|
