Available as a complete kit only from your dealer at $49+.
Built for exact fit.
Viton® (Fluorocarbon, FKM): Fluorocarbon rubber has excellent resistance to high temperatures, ozone, oxygen, mineral oil, synthetic hydraulic fluids, fuels, aromatics and many organic solvents and chemicals. Low temperature resistance is normally not favorable and for static applications is limited to approximately –15°F (–26°C) although in certain situations it is suitable down to –40°F (–40°C). Under dynamic conditions, the lowest service temperature is between 5°F and 0°F (–15°C and –18°C). Gas permeability is very low and similar to that of butyl rubber. Special fluorocarbon compounds exhibit an improved resistance to acids, fuels, water and steam.
Heat resistance: Up to 400°F (204°C) and higher temperatures with shorter life expectancy.
Cold flexibility: Down to –15°F (–26°C) (some to –40°F (–40°C)).
Chemical resistance: Mineral oil and grease, low swelling in ASTM oil No. 1, and IRM 902 and IRM 903 oils. Non-flammable hydraulic fuels in the group HFD. Silicone oil and grease. Mineral and vegetable oil and grease. Aliphatic hydrocarbons (fuel, butane, propane, natural gas). Aromatic hydrocarbons (benzene, toluene). Chlorinated hydrocarbons (trichlorethylene and carbon tetrachloride). Fuels, also fuels with methanol content. High vacuum. Very good ozone, weather and aging resistance.
Free Shipping (Lower 48 States)!
$10.00
+ $5.00
+ $20.00
Fuel Drain Valve Kit
Fits Powerstroke 7.3L 94-03.
Fixes that Fuel Leak!
Free Shipping (Lower 48 States)!
$56.99
$29.99
IPR Valve Reseal Kit
Complete Set of O-Rings, Washer, and Nut.
Leaking or damaged Injection Pressure Regulator seals can cause poor idle, stalling and no-start problems.
Replacing the IPR Valve may be unnecessary (and expensive!) in most cases.
Help recondition your IPR back to life.
IPR is available as a complete kit only from your dealer at $250+!
Built for exact fit.
Free Shipping (Lower 48 States)!
$36.99
Motorcraft Injector O-Ring Kit
Motorcraft 8-sets of Brand New 7.3L Ford Powerstroke Diesel Injector O-ring kits.
Built for exact fit.
Free Shipping (Lower 48 States)!
$99.99
High Pressure Oil Pump (HPOP) O-Ring
Set of 2 O-Rings.
Fixes that Pesky Oil Leak!
Easy to install.
Made of Veton (A tough material that resists leaking and tearing).
Built for exact fit.
Free Shipping (Lower 48 States)!
$29.00
$39.00
Turbo Re-Install Kit
Complete Kit with Bolts, Brackets and O-rings.
Fixes that Pesky Oil Leak!
Use when installing a new Compressor wheel or removing and installing Turbo housing.
Free Shipping (Lower 48 States)!
$75.00
Turbo Pedestal O-ring Kit
2 O-rings.
Fixes that Pesky Oil Leak!
Use when installing a new Compressor wheel or removing and installing Turbo housing.
Free Shipping (Lower 48 States)!
$15.00
ICP/High Pressure Crossover O-Rings
Did you install HX (High Pressure Crossover) line? Is it leaking?
Did you remove your ICP or does it leak?
Made for exact fit.
Made of Veton (A tough material that resists leaking and tearing).
Built for exact fit.
Free Shipping (Lower 48 States)!
$15.00
If you see it cheaper elsewhere, call us and we'll try to meet or beat the price!
Featured Product
Ultimate Power Package!
For your '99.5-2007 PowerStroke 7.3L or 6.0L
SCT XCAL 3 Programmer, w/Custom Tunes. Adds up to 150 Horse Power, 290 ft-lbs torque!
Fits all 99-Up 7.3L and 6.0L Powerstroke Turbo Diesel Engines (F-250, F-350).
MagnaFlow Stainless T-409 Turbo Back System.
AFE Stage I Cold Air Intake System.
3-Gauge Painted Pillar with Boost, Trans, and EGT Autometer Gauges.
Fully Painted, Pre-assembled and wired (Ultralite, Z-Series, Phantom, or Sport-Comp)
